Black polish – the most sophisticated and challenging finishing technique – is performed exclusively on the tourbillon bridge and cage. It can take up to five days to polish one single part.

6002138269_3547a2189c_b.jpg
The Glashütte ribbing emulates a gently rippled effect. The pattern decorates the three-quarter plate and some other large parts of the framework.

6002138415_353113d90d_b.jpg
Chamfering: At Lange, every single bevel on almost all parts is polished by hand, at an angle of exactly 45 degrees. Sharp inner corners are particularly challenging.

6002138917_1b9ecb0f84_b.jpg
The mirror-smooth surface of the flat polish is achieved by rubbing the part in a figure-eight motion on special foils coated with diamond dust.

6002139829_092550cf1b_b.jpg
Contour grinding: The contours of all framework components are given a matt finish to create a vivid interplay with the polished edges.

6002685958_b64a1b0495_b.jpg
Circular graining is used on round shapes such as wheels. Unlike most other finishes, this one is applied by rotating the part around the tool.

6002686478_5da2269a9b_b.jpg
The perlage consists of small, overlapping circles, achieved with a rotating grinding tip. In A. Lange & Söhne watches, it is mainly used for bridges and plates.

6002686992_327024c87d_b.jpg
Linear finish: The fine lines in a parallel direction are achieved by sliding apart in one direction over a piece of abrasive paper.

6002687314_034997357b_b.jpg
The engraving turns each A. Lange & Söhne timepiece into a unique and personal belonging: Every balance cock is hand engraved with lavish floral elements by one of six master engravers.

6002687828_9c4c9e8a0e_b.jpg
The sunray finish is mainly used on bigger wheels and parts of the framework. The graining results in a spiral pattern.

Casio G-Steel Carbon G-Shock
Jason Pitsch
Posted by:Jason Pitsch

Author, photographer, and editor. Learn more on Linkedin.